Signal Saver IPC (140-2000 VA)
Battery Backup System for Traffic Light
Battery Backup System for Traffic Light
Features
140 VA - 2000 VA
Self standing power system with a superior design that fits into a 18" rack
Fully compatible with Caltrans 332 & 170 Cabinet, 2070 controller & internal cabinet configuration
1000 VA @ 97% off
Power factor (load) is
0.7
Minimum 2 hours @ full
load of 750 Watts
Elapsed timer counter
Physical Dimension:
19"W x 5.1"H x
15"D
| Power Rating | 140, 280, 420, 570, 700, 857, 1000, 1250, 2000 VA |
| Input Voltage | 120V Single Phase |
| Input Voltage Range | 138 VAC to 85 VAC |
| Input Frequency | 60 Hz ±0.5 Hz |
| Input Protection | Single pole switch & inline fuse |
| Transient Protection | ANSI @ 62.41 IEEE 587 (A&B) |
| Output Voltage | 120 VAC 60 Hz single phase |
| Output Voltage Reg. | ±0.2% from no load to full load and from high battery to low battery |
| Output Frequency | 60 Hz ±3 Hz, compatible with all NEMA flasher |
| Output Wave Form | Complete from line. Output neu-tral Sinse Wave |
| Overload Capability | 125% for ten (10) minutes |
| Fault Condition | The unit shall withstand a short circuit on any output without causing damage to the system. However a single or multiple sustained short will be fuse cleared within 20 seconds or less. |
| Efficiency | 97% |
| Power Factor | 0.7 leading to unity |
| Environmental Humidity | 0 - 95% RH w/ no condensation |
| Operating Temperature | -35° to 74°C. (-30° - 165°F) |
| Storage Temperature | 35° to 74°C. (-30° - 165°F) |
| Cabinet | 19"(W) x 5.1"(H) x 15"(D) |
Signal Saver IPC
Battery Backup System for Traffic Signal Heads.
Traffic Signal Battery Backup System
- Signal Saver IPC (140 - 2000 VA)
- BBS with Meter/Dist. (400 - 1300 Watts)
- Telocom Battery Backup (100 - 1600 Watts)
Data Sheets